After this, remove the induction panel

shapanqqcceqd · Post by **shapanqqcceqd** » Tue Feb 18, 2025 11:09 am

Then proceed to removing the front panel and control unit . To do this, carefully disconnect the cable from the control module. Remove the grounding fastener and the plastic fastener that secures the module, and take out the control panel.

The door is dismantled . It is opened and the limiting plate is removed using a flat-head screwdriver. All actions are performed carefully so as not to damage the rubber seal. Then the door is lifted and removed. During reassembly, make sure that the door is installed parallel to the frame, without gaps. If necessary, adjust it.

To remove the magnetron, disconnect the cables from the new zealand telegram data transformer and capacitor . Remove the fasteners holding them to the frame. Disconnect the assembly until the tip comes out to the end of the waveguide. After the magnetron is installed in place, check the radiation level. It should not be higher than 5 mW/cm².

Then remove the interference suppression filter by disconnecting the power harnesses from it and removing the fastener that secures the ground wire to the back wall. Press on the two plastic latches and remove it. After that, disconnect the power harnesses from the tank, unscrew the screw, and secure the ground wire of the high-voltage diode. At the next stage, disconnect the harnesses from the current relay and the fan. Remove the fasteners and remove the fan.

If you need to get the backlight lamp , disconnect the wires from it and remove the fasteners that secure the air duct to the magnetron. Press the latches of the air duct to remove the indicator panel.

Note: To remove parts from a microwave oven, follow the same principle: disconnect the wires, remove the fasteners, and remove the part.

The equipment is assembled in the reverse order . To simplify the process, it is better to record the disassembly of the device on camera or take photos. When assembling the microwave oven, act very carefully so as not to damage it and not cause a leak of microwave radiation.